Y-cam Knight Manuel d'utilisateur télécharger pdf (Page 40)

Firewall security features built into the router may prevent users from accessing the Y-cam Knight over the

Internet. The router connects to the Internet over a series of “ports”. The default ports used by the Y-cam

Knight are usually blocked from access over the Internet, therefore, these ports need to be made

accessible. This is achieved using the Port Forwarding function on the router. The ports used by the camera

must be opened through the router for remote access to your Y-cam Knight. Check your router’s user

manual for specific instructions on how to open and route ports on you router.

Important: Some ISPs block access to port 80 and other commonly used Internet ports. Check with your

ISP in order to open the appropriate ports. If your ISP does not pass traffic on port 80, you will need to

change the camera’s default port number from 80 to a different number such as 8000.

Viewing Your Camera

To access the Y-cam Knight from a computer on your local network, simply enter the IP Address of the

Camera followed by a colon and the camera’s port number. It is not necessary to enter the colon and port

number if you are using the camera’s default port 80.

To access the Y-cam Knight from the internet, type the external IP Address of the router, followed by a

colon, and the port number of your camera (e.g., Http://202.115.122.96:8000).

Note: You can check all your settings by clicking on “System” in the top right section of the “Settings” page.

(See page 36). In the UPnP section, you will find your external IP address, your external port and the

address you need to type in the Internet Browser’s address bar.

Note: If your UPnP gateway is not configured, you can find your external IP address by visiting

www.whatismyipaddress.com or www.myipaddress.com

11.1 Port Forwarding

11.0 ADVANCED SETTINGS

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46 47

Pas de commentaire

Y-cam Knight Manuel d'utilisateur Page 40